Signage

EXPOSURE UNITS

UVMARK+

Uvmark : ultravilolet exposure unit for Polycolor: photosensitive anodized aluminium

Exposure unit , for Metalphoto ®, Metalphoto Plus ®, Polycolor ® and ID MARK ® plates up to 254 x 305 mm

Featuring :

  • mechanical timer to switch on/off the lamp
  • light source and lamp power selectors
  • honeycombed foam system to keep the film and processed plate in close contact.

UVMARK GF +

Ultraviolet exposure unit for Polycolor: photosensitive anodized aluminium

Exposure unit for Metalphoto ®, Metalphoto Plus ®, Polycolor ® and ID MARK ® plates up to 305 x 508 mm

Featuring :

  • memory digital timer to switch on/off the lamp. Ring when the cycle is over
  • Vacuum system to keep the film and processed plate in close contact

DEVELOPING AND FIXING EQUIPMENT

Automatic coating machine

Coating machine and rod for Polycolor: photosensitive anodized aluminium

AUTOMATIC COATING MACHINE : Used to coat plates with PolyColor ® resist in order to add new colours.
With tray to save resist. 
For plates up to 305 x 508 mm

Coating rod

Coating machine and rod for Polycolor: photosensitive anodized aluminium

To manually and evenly coat plates with resist to add new colours.
For plates up to 305 x 508 mm

SEALING TANK

Sealing tank for Polycolor: photosensitive anodized aluminium

Stainless steel sealing tank : Sealing step causes aluminium pores to swell shut and traps images inside the anodic layer of Metalphoto ® plates.
4 plates size 305 x 508 mm can be simultaneously sealed inside this 26 liter Tank with thermostat to control water temperature.

OPTION : SHAPING EQUIPMENT

9001 shears

Shears for Polycolor: photosensitive anodized aluminium

9001 SHEARS will cut aluminium plates up to 305 mm (12’’) wide and 1.5 mm thick.
Free access to the cutting blade is prevented by heavy shielding along both sides of the blade.
A safety latch is fitted to the pivot to prevent operation without it first being released.
The cutting bed is fitted with a rule for positional accuracy.

DM 525 shears

Guillotine for Polycolor: photosensitive anodized aluminium

DM 525 SHEARS has a cutting capacity of 63,5 cm for 1.5 / 2 mm thick aluminium plates.
On lowering the operating handle, a spring loaded clamp is activated which holds the material securely during cutting. 
These shears comprise an epoxy coated cast aluminium frame fitted with hardened and ground steel blades protected by a clear acrylic front safety guard protecting the operator and making it possible to see the blades so that the material to be cut can be aligned accurately. 
Metric edge scales and adjustable front and back stops for batch work.

Corner rounder

Corner rounder for Polycolor: photosensitive anodized aluminium

CORNER ROUNDER : quick corner rounding facility for labels and front panels. The table is split into two halves, each containing 90 degree stops, in the angle of which is a hardened radius of either 6 mm or 4 mm.
The punch has been ground to simultaneously marry both of these rounds when driven down by the cam actioned handle.
The material to be rounded is slid from the left or right hand side positively into the stops, to leave an overhang which is sheared through by the punch to leave a clean corner of either 6 mm or 4 mm radius.
12.8 x 12.8 mm (5 x 5’’) steel plate with screw holes for bench fixing.