| |
 |
| UVMARK+ | |
 | |
| Exposure
unit , for Metalphoto ®, Metalphoto Plus ®, Polycolor ® and ID MARK
® plates up to 254 x 305 mm | | |
| Featuring : | - mechanical
timer to switch on/off the lamp
- light source and lamp power selectors
- honeycombed
foam system to keep the film and processed plate in close contact.
|
|
| UVMARK GF + | |
 | |
| Exposure
unit for Metalphoto ®, Metalphoto Plus ®, Polycolor ® and ID MARK
® plates up to 305 x 508 mm | | |
| Featuring : | - memory
digital timer to switch on/off the lamp. Ring when the cycle is over
- Vacuum
system to keep the film and processed plate in close contact.
|
| | |
| DEVELOPING
AND FIXING EQUIPMENT |
 | |
Motorized processing machine with proper speed to secure even development of
Metalphoto ® plates.
A 305 x 508 mm plate is processed in about 30 sec.
The machine is equipped with emptying taps to save chemicals after use, and
exclusive driving system for easy maintenance | |
|
 | |
Stainless steel sealing tank : Sealing step causes aluminium pores to swell
shut and traps images inside the anodic layer of Metalphoto ® plates.
4 plates size 305 x 508 mm can be simultaneously sealed inside this 26 liter
Tank with thermostat to control water temperature | |
|
| OPTION
: SHAPING EQUIPMENT |
|
|
| 9001 shears | |
 | | 9001
SHEARS will cut aluminium plates up to 305 mm (12’’) wide and 1.5 mm
thick.
Free access to the cutting blade is prevented by heavy shielding along
both sides of the blade.
A safety latch is fitted to the pivot to prevent
operation without it first being released.
The cutting bed is fitted with
a rule for positional accuracy. |
| DM 525 shears | |
 | | DM
525 SHEARS has a cutting capacity of 63,5 cm for 1.5 / 2 mm thick aluminium plates.
On lowering the operating handle, a spring loaded clamp is activated which holds
the material securely during cutting.
These shears comprise an epoxy coated
cast aluminium frame fitted with hardened and ground steel blades protected by
a clear acrylic front safety guard protecting the operator and making it possible
to see the blades so that the material to be cut can be aligned accurately.
Metric edge scales and adjustable front and back stops for batch work. |
| Corner
rounder | |
 | | CORNER
ROUNDER : quick corner rounding facility for labels and front panels. The table
is split into two halves, each containing 90 degree stops, in the angle of which
is a hardened radius of either 6 mm or 4 mm.
The punch has been ground to
simultaneously marry both of these rounds when driven down by the cam actioned
handle.
The material to be rounded is slid from the left or right hand side
positively into the stops, to leave an overhang which is sheared through by the
punch to leave a clean corner of either 6 mm or 4 mm radius.
12.8 x 12.8 mm
(5 x 5’’) steel plate with screw holes for bench fixing. | |
| | |
